Change the value via the API

Everything about Z-Wave radio devices with eedomus

Change the value via the API

Messagepar warzo » 31 Oct 2023 09:51


This is my first post here, and I'll briefly explain the situation.
I have a gate connected to an Eedomus box using the Z-Wave protocol.

When I execute my "Open" / "Close" programming on the box's panel (set value to 0 or 100), everything works as expected.

I tried to do the same thing via the API, using a SET request and changing the value from 0 to 100. See below:

From the box's panel, the value changes correctly, but nothing happens physically (the gate doesn't move, and there are no signs of any signal).

So, I would like to know if I missed something, an option, or a security setting that I haven't noticed?

Thank you for reading and for any potential assistance you can provide.
Messages : 2
Inscription : 31 Oct 2023

Retour vers Z-Wave devices

Qui est en ligne ?

Utilisateurs parcourant ce forum : Aucun utilisateur inscrit et 3 invité(s)